SYSMEX SF-3000 - Delete File

QUALITY CONTROL
Sysmex SF-3000 Operator's Manual -- Revised September 1995 6-3
2. DELETE FILE
To use the files for new lots of control material or to change the control material level
(levels are: Normal, Abnormal Low and Abnormal High), all existing data should be
deleted from the memory of the particular QC file. The QC -- Delete Files program can
be used to delete any or all of the data from X /L-J files (File Nos. 1-12) and/or the
X M file.
NOTE: Individual control data results can also be deleted by selecting [Delete]
- [Plot] from the submenu, and using the cursor to specify the exact
control data results to be deleted.
(1) Press [QC] keypad in the root menu. QC second menu will be displayed.
(2) From the QC submenu, select [Delete]. The password entry screen will appear.
Input the password and press [ENTER].
(3) From the Delete submenu, press [File]. A list of all the files will appear on the
Delete File screen.
Plot ReturnFile
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
Cancel OK
< Delete File >
File Lot No. Exp Date Level Mode
1
2
3
4
5
6
7
8
9
11
12
10
12345678
12345679
12345680
12345678
12345679
12345680
1996/05/31
1996/05/31
1996/05/31
1996/05/31
1996/05/31
1996/05/31
Normal
Low
High
Low
High
Manual
Manual
Manual
Closed
Closed
Closed
↑
↓
Normal
XM
Plot ReturnFile
Figure 6-1: Delete File Selection Screen
(4) Using the [↑] and [↓] keys, select the file to be deleted.