QUALITY CONTROL, QC Chart
6-40 Sysmex SF-3000 Operator's Manual -- Revised September 1995
7.5 Cal. History
After calibration has been performed, a yellow vertical dotted line, marking only the latest
calibration appears on the QC Chart. This line is midway between two plotted points.
The calibration history can be referred in QC mode for operator's convenience to confirm
the calibrated parameters.
(1) Press [QC] keypad in the root menu. The QC second menu will be displayed.
(2) From the QC submenu, select [Cal. History].
NOTE: If [Cal. History] keypad is not displayed on the LCD, press [More] to
change the displayed root menu.
(3) The calibration history will appear. Refer to Chapter 7: Calibration for detail of the
calibration history.
To Next Page
Loading...
