SYSMEX SF-3000 - Chapter 11: System Setup and Configuration; 4. Tray Installation

viii Sysmex SF-3000 Operator's Manual -- Revised December 1995
APPENDIX A: MENU TREE
APPENDIX B: INSTALLATION
1. PREINSTALLATION............................................................................. B-2
1.1 Unpacking Check List .......................................................... B-2
1.2 Supplementary Parts Information ......................................... B-5
2. LAYOUT AND WORK SPACE ............................................................ B-6
3. REMOVING PACKING MATERIAL................................................... B-7
3.1 Front Cover........................................................................... B-7
3.2 Front Panel............................................................................ B-7
3.3 Main Unit Chassis................................................................. B-9
3.4 SRV..................................................................................... B-10
3.5 Rear Panel........................................................................... B-10
3.6 Pneumatic Unit ................................................................... B-11
4. TRAY .................................................................................................... B-11
5. BAR CODE ID READER (Optional)................................................... B-12
6. CP SAMPLER UNIT (Optional) .......................................................... B-13
6.1 Main Unit............................................................................ B-13
6.2 Sampler Unit....................................................................... B-14
6.3 Connection to Main Unit .................................................... B-15
7. MANUAL CP UNIT (Optional) ........................................................... B-17
7.1 Main Unit............................................................................ B-17
7.2 Manual CP Unit .................................................................. B-18
7.3 Connection to Main Unit .................................................... B-18
8. TUBE CONNECTION.......................................................................... B-22
8.1 Vacuum Line ...................................................................... B-22
8.2 Pressure Line ...................................................................... B-22
8.3 Reagent Container Preparation ........................................... B-23
8.4 Reagent Lines ..................................................................... B-26
8.5 Waste Container.................................................................. B-27
9. BATTERY BACKUP ........................................................................... B-28
10. CABLE AND POWER CORD CONNECTIONS................................ B-29
10.1 Output Connections ............................................................ B-29
10.2 Pneumatic Cable Connections ............................................ B-30
10.3 Power Cord Connections .................................................... B-30
11. POWER ON AND SYSTEM SETUP................................................... B-31
11.1 Power On ............................................................................ B-31
11.2 System Setup ...................................................................... B-31
11.3 System Check ..................................................................... B-32