INTRODUCTION, Safety
Sysmex SF-3000 Operator's Manual -- Revised September 1995 1-7
6.4 Laser Safety
The SF-3000 uses a semiconductor laser unit. Though this laser unit is placed in the
shield box, the operator must observe all NOTES, CAUTIONS and WARNINGS
concerning laser handling.
WARNING!: DO NOT remove the shield box cover of the Laser Unit.
Semiconductor Laser
Unit Cover
< Top View >
< Left Side View >
NOTE: This caution label is located
inside the Laser Unit Cover.
Figure 1-2: Location of Laser Unit and Labels
(Left Interior of the Main Unit)
Refer to Chapter 5, Section 6 for further information on laser handling.
To Next Page
Loading...
