MAINTENANCE & SUPPLIES, Replacements
5-68 Sysmex SF-3000 Operator's Manual -- Revised December 1995
(5) Set a new Belt No. 6 (found in the supply parts) on the pulleys. Make sure the belt is
not twisted. See the figure below.
CAUTION: Take care not to damage the belt by the edge or corner of metal
parts.
Pulley
Motor Belt
GOOD
NO GOOD
Figure 5-8-41: Set Motor Belt
(6) Connect the connectors.
(7) Turn ON the power. Visually check the motor operation.
(8) Release the stop bar and close the front cover.
(9) Press [Mainte.] keypad in the root menu, then press [Test].
(10) Press [Mixing Motor] key from the Test submenu.
(11) Press the Start Switch to start the mixing motor test program and verify that the
rotation speed is stable within the normal range of 1600 - 2000 rpm.
NOTE: Refer to Chapter 8, Section 3.3: Test Motor for the test program.
(12) Record the replacement on the maintenance log.
Sysmex SF-3000 Operator's Manual -- Revised March 2001
To Next Page
Loading...
