QUALITY CONTROL, Target/Limit, Manual Change
Sysmex SF-3000 Operator's Manual -- Revised September 1995 6-27
(7) The item displayed above the numerical keypads can be manually input. Use the
[←], [→], [↑] and [↓] keys to move the cursor to the values to be input. The
cursor switches between the Target and Limit columns and moves up and down
inside the columns.
NOTE: • If the [↓] key is pressed when the cursor is at the bottom of the screen,
the list will scroll up one item. (The cursor will be at the bottom of the
screen.) However, if the cursor is on GRAN-Y(W), the list will not
scroll when this key is pressed.
If the [→] or [ENTER] key is pressed when the cursor is on the last
Limit item on the screen, the list will scroll up one item and the cursor
will move over to the Target side. (However, the list will not scroll and
the cursor will not move if the cursor is on GRAN-Y(W) Limit when
either of these keys are pressed.)
• If the [↑] key is pressed when the cursor is at the top of the screen,
the list will scroll down one item. (The cursor will be at the top of the
screen.) However, if the cursor is on WBC, the list will not scroll when
this key is pressed.
If the [←] key is pressed when the cursor is on the first Target item on
the screen, the list will scroll down one item and the cursor will move
over to the Limit side. (However, the list will not scroll and the cursor
will not move if the cursor is on WBC Target when either of these keys
are pressed.)
(8) Input the new values. The value where the cursor is positioned will be entered.
When an incorrect value is input, press [C] to clear the value and input a correct
value again.
(9) Press [ENTER] to confirm the new value. The cursor will move to the next value.
(10) Press [QUIT] key. The Target/Limit Setting Window will appear.
(11) Press [Quit] key. The confirmation window will appear as shown below.
Set Target/Limit?
Cancel
OK
Figure 6-25: Confirmation Message Window
(12) Press [OK] key to set the new settings into the specified file and end the program.
Press [Cancel] to cancel the new settings and end the program.
To Next Page
Loading...
Need help?
General
