SYSMEX SF-3000 - Page 484

SYSTEM SETUP, Data Criteria
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-15
(4) Press the desired keypad to execute the program. Proceed each program by
referring to the following sections.
(5) When [Quit] key is pressed to exit the setting program, the confirmation message
window will appear. Press the appropriate key [Continue], [Set] or [Cancel].
Mark
LL
WBC
3
6
3
3
UL
Limits
DP:1234567890123
Sysmex
XM HC GP DP SU
Ready Manual Mode Next No.1234567890123
Sampler
3.00 [X10 /uL]15.00
RBC 2.50 [X10 /uL]
5.50
HBC 8.0 [g / dL]17.0
HCT 2 6 . 0 [ % ]50.0
MCV 86.0 [fL]110.0
MCH 26.0 [pg]38.0
MCHC 3 1 . 0 [g / dL]37.0
PLT 5 0 [X10 /uL]400
RDW-SD 37.0 [fL ]54.0
RDW-CV 11.0 [ % ]16.0
PDW 9.0 [ f L]17.0
MPV 9 .0 [ f L ]13.0
P-LCR 13.0 [ % ]43.0
NEUT% 37 .0 [ % ]72.0
LYMPH% 20.0 [ % ]50.0
MONO% 0 . 0 [ % ]14.0
EO0.0 [%]6.0
BASO% 0 . 0 [ % ]1.0
NEUT# 1.5 [X10 /uL]7.0
→
←
↓
↑
Mark
Limits
Stop
Limits
Stop
Condition
Critical
Limits
Return
Continue Set Cancel
Settings will be finished.
Figure 11-12: Example of End of Setting Window
Continue : To return to the previous screen so that setting can be continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.