SYSTEM SETUP
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-17
(3) Input the new limits using the numeric keys and press [ENTER].
NOTE: If you do not want to use a particular parameter in the mark limits, set
zero for the lower limit and set a very high value (e.g. 999.9) for the
upper limit.
(4) Press [QUIT] key to exit the program. The confirmation message will appear.
Press the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to Mark Limits setting screen so that setting can be
continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.
To Next Page
Loading...
