SYSTEM SETUP
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-19
NOTE: • All 23 parameters are present for setting, but all of them cannot fit into
a single screen; use the
[↑] and [↓] keys to scroll up and down.
• Pressing [ENTER] key after inputting the new value has the same
effect as pressing the
[→] key.
(3) Input the new limits using the numeric keys and press [ENTER].
(4) Press [QUIT] key to exit the program. The confirmation message will appear.
Press the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to Critical Limits setting screen so that setting can be
continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.
To Next Page
Loading...
