SYSTEM SETUP
Sysmex SF-3000 Operator's Manual -- Revised September 1995 11-23
The following errors can be specified as conditions for stopping auto mode
analysis:
Aspiration ERR : Analysis stops if "Blood Asp Sensor Error", "Sample
Not Asp Error", or "Short Sample" occurs.
Inadequate Sample : Analysis stops if the Blood Volume Sensor detects a
short sample.
X M Limit ERR : Analysis stops if X M limit error occurs.
L-J Limit ERR : Analysis stops if L-J limit error occurs.
ID Read ERR : Analysis stops if sample ID No. cannot be read.
Control Expired : Analysis stops if analyzed control lot of SF CHECK is
expired.
Rack ID Read ERR : Analysis stops if rack ID No. cannot be read.
Low Count ERR : Analysis stops if sample with extremely low count value
occurs.
Stop Limit ERR : Analysis stops if sampler stop limit error occurs.
Manometer ERR : Analysis stops if "RBC Slow To Start", "RBC Count
Too Long", "RBC Fast To Start", or "RBC Count Too
Short" occurs.
(2) Press the box key to the right of each item to select the condition. The selected
conditions will be marked by a "√". To disable the setting for the condition, press
the key pad marked "√".
(The factory setting is "√" for all conditions.)
(3) Press [Quit] key to exit the program. The confirmation message will appear. Press
the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to Stop Conditions setting screen so that setting can be
continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.
To Next Page
Loading...
Need help?
General
