SYSMEX SF-3000 - Page 505

SYSTEM SETUP, HC Setting
11-36 Sysmex SF-3000 Operator's Manual -- Revised September 1995
12digits 13digits
Sample No.
RDW Output
P-LCR Output
PDW Output Transmit
Not Transmit
Not Transmit
Transmit
RDW-SD
+RDW-CV
RDW-SD RDW-CV
< HC Settings >
More Quit
H C
Setting
G P
Setting
D P
Setting
Return
DP:1234567890123
Sysmex
XM GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
√
√
√
√
Figure 11-29: HC Setting Screen - 2
Sample No. : Either "12 digits" or "13 digits" can be selected. (The factory
setting is "13 digits".)
RDW Output : RDW output can be selected.
(The factory setting is "RDW-SD + RDW-CV".)
PDW Output : Either "Transmit" or "Not Transmit" can be selected.
(The factory setting is "Transmit".)
P-LCR Output : Either "Transmit" or "Not Transmit" can be selected.
(The factory setting is "Transmit".)
(4) Press [Quit] key to exit the program. The confirmation message will appear. Press
the appropriate key [Continue], [Set] or [Cancel].
Continue : To return to HC setting screen so that setting can be continued.
Set : To save the new settings. Program ends.
Cancel : To cancel the new settings. Program ends.