SYSMEX SF-3000 - Page 598

iv Sysmex SF-3000 Operator's Manual -- Revised July 1996
[G]
General Safety 1-6
General Set Up, Setting Programs 11-41
GP (Graphic Printer)
Indicator 1-11
Settings 11-37
Test 8-81
GP Not Ready, Troubleshooting 8-52
GP Off Line, Troubleshooting 8-52
GP Output, Work List 3-13
GP Paper Empty, Troubleshooting 8-54
Graphic Display
Calibration Data 7-14
Stored Data 4-20
[H]
Hand Clipper, Replace 5-62
Hand Initial Position Error,
Troubleshooting 8-31
Hand Lower Position Error,
Troubleshooting 8-32
Hand Move Position Error,
Troubleshooting 8-31
Hand Upper Position Error,
Troubleshooting 8-32
Hard Copy 1-16
Hard Disk Drive 10-30
Hazardous and Biohazardous Material 1-6
HC Communication Error,
Troubleshooting 8-50
HC (Host Computer)
Connection B-29
Indicator 1-11
Settings 11-35
Test 8-82
HD Indicator 1-12
Heat Compensation 1-20
Help, QC, Target/Limit 6-19
HGB Analysis Flow 10-6
HGB Drain Error, Troubleshooting 8-42
HGB Error, Troubleshooting 8-42
HGB/HCT Auto Program, Overview 7-3
HGB/HCT Manual Program, Execute 7-15
Execute 7-16
Histogram Flags 10-15
Histogram Representation 10-14
Host Errors, Troubleshooting 8-49
Host Format C-8
Humidity, Environmental 1-20
[I]
ID Errors, Troubleshooting 8-48
ID Indicator 1-12
ID Read Error, Troubleshooting 8-48
ID Read Status, Edit Sample Info. 4-48
ID Reader
Adjustment 9-10, B-34
Install B-12
Setting 11-52
Test 8-74
ID Unit Com. Error, Troubleshooting 8-44
Indication Mark, Reagent Cap B-23, B-25
Informational Headings 1-3
Input Lot Information, QC File 6-28
Input New Lot, Reagent 5-47
Input/Output Signals, Serial Interface C-2
Inquiry Data Format C-14
Install
Bar Code Reader B-12
Manual CP Unit B-17
Sampler Unit B-13
Tray B-11
Installation Environment 1-20
Installation Requirements 1-19
Interface Circuit, Serial Interface C-3
Interpretive (IP) Message 4-2
Abnormal 4-3
List 4-19
Suspect 4-3
IP Messages Screen (P6), Stored Data 4-18
[K]
Keyword, Order Inquiry, Set 11-56
[L]
L-J Control 6-47
<L-J Limit Error>, Troubleshooting 8-55
Laser Power Error, Troubleshooting 8-38
Laser Safety 1-7
Laser Unit
Location 1-7
Test 8-70
Visual Inspection 5-26
Layout and Work Space B-6
LCD Screen 1-10
Contrast Adjustment 9-9
Test 8-78
Left Interior, Main Unit 10-26
Left Side, Main Unit 10-24
Limit# or Limit%, QC, Select 6-6