SYSMEX SF-3000 - 3. Quality Control Analysis Procedures; 4. Weekly Maintenance Procedures; Chapter 6: Quality Control (QC); 4. QC Parameter Selection

iv Sysmex SF-3000 Operator's Manual -- Revised September 1995
8. REPLACEMENTS................................................................................. 5-46
8.1 Replace Reagent .................................................................. 5-46
8.2 Replace the Piercer (Auto Sampler Unit) ............................ 5-51
8.3 Replace the Piercer (Manual CP Unit) ................................ 5-58
8.4 Replace the Hand Clipper.................................................... 5-62
8.5 Replace the Rubber Plate No. 39......................................... 5-63
8.6 Replace the Anti-Shock Rubber No. 49 .............................. 5-64
8.7 Replace the Fuses ................................................................ 5-65
8.8 Replace the Belt No. 6 ......................................................... 5-67
9. RESET THE COUNTER ....................................................................... 5-69
10. FORMAT FD.......................................................................................... 5-72
11. SUPPLIES AND REPLACEMENT PARTS LISTING......................... 5-74
CHAPTER 6: QUALITY CONTROL
1. INTRODUCTION.................................................................................... 6-1
1.1 Types of QC Method............................................................. 6-2
1.2 QC Parameters To Be Monitored.......................................... 6-2
2. DELETE FILE ......................................................................................... 6-3
3. SYSTEM SETTINGS .............................................................................. 6-5
4. QC PARAMETER SELECTION ............................................................ 6-7
4.1 Selecting QC Parameter ( X /L-J Control) ........................... 6-7
4.2 Selecting QC Parameter ( X M Control) .............................. 6-8
5. SETTING X M CONTROL ................................................................. 6-10
5.1 Executing the X M Control Settings Program................... 6-10
6. TARGET/LIMIT.................................................................................... 6-13
6.1 Display................................................................................. 6-13
6.2 Read FD (Floppy Disk) ....................................................... 6-15
6.3 Help ..................................................................................... 6-19
6.4 Auto Setting......................................................................... 6-21
6.5 Manual Change.................................................................... 6-25
6.6 Lot Information ................................................................... 6-28
7. QC CHART............................................................................................ 6-31
7.1 Select File............................................................................ 6-33
7.2 Output QC Chart/Data......................................................... 6-34
7.3 Mean/SD (Calculation)........................................................ 6-36
7.4 Delete Plot ........................................................................... 6-38
7.5 Cal. History ......................................................................... 6-40
8. MANUAL QC ANALYSIS ................................................................... 6-41
9. SAMPLER QC ANALYSIS (L-J) ......................................................... 6-44
10. QC METHODS AND APPLICATIONS............................................... 6-47
10.1 X Control .......................................................................... 6-47
10.2 L-J Control .......................................................................... 6-47
10.3 X M Control....................................................................... 6-48
11. VARIABLE TARGET FUNCTION...................................................... 6-51
11.1 How Target Values Are Calculated..................................... 6-51
11.2 Variable Target Function and Erroneous Data.................... 6-52
12. CONTROL CHART DEFINITION....................................................... 6-53