Replacing and filling CBS pump brake fluid
●Disassemble:
Reservoir [A]
●Disassemble:
Reservoir cap and reservoir gasket
Loosen the bleed screw of slave pump of front brake
[B], and vacuumize from the bleed screw using a
vacuum pump to pump the brake fluid completely.
●Add new brake fluid to master cylinder reservoir,
keep the brake fluid in the reservoir not less than 1/3 of
its volume, and pull the brake lever for several times
quickly, and lock the bleed screw of slave cylinder [B].
○Operate the brake lever and feel. If you feel that it
is softer than before, please repeat the above actions
Remark
○
Check the brake fluid level in the reservoir
frequently and add new brake fluid as needed. If the
brake fluid in the reservoir runs out during the
replacement of the brake fluid, the air in the brake
pipe must be exhausted.
○CBS pump
: Please repeat the above steps to
remove the calipers.
●Properly install the covers of rear brake reservoir and
CBS pump reservoir in the following steps.
○
First, tighten the cover [B] of rear brake fluid
reservoir with your hands clockwise [C] until you feel a
little resistance, indicating that the cover has been fixed
on the cup, then hold the cup [A] and rotate it by 1/6
turn [D].
●Tightening:
Locking torque of front brake fluid reservoir cover
stopper screw: 1.2N·m
●Tighten the air drain screw and install the rubber
- 105 -
To Next Page
Loading...
Need help?
General
