SUBTASK 72-35-00-118-059-G00
WARNING
DO NOT GET SOLVENTS IN YOUR MOUTH OR EYES, OR ON YOUR SKIN.
DO NOT BREATHE THE FUMES FROM SOLVENTS. PUT ON A RESPIRATOR,
PROTECTIVE SPLASH GOGGLES, AND GLOVES WHEN YOU USE
SOLVENTS. KEEP THE SOLVENTS AWAY FROM SPARKS, FLAME, AND
HEAT. SOLVENTS ARE POISONOUS AND FLAMMABLE. SOLVENTS CAN
CAUSE INJURIES TO PERSONNEL, AND DAMAGE TO EQUIPMENT.
(2) Clean the area all around the bearing with solvent, B00090 or technical grade methyl ethyl
ketone, B50046, remove all the dirt, oil, and grease.
SUBTASK 72-35-00-348-060-G00
(3) Spray release compound on all the surfaces that will touch the RTV.
SUBTASK 72-35-00-348-061-G00
(4) Apply RTV 106 adhesive, A01050 [C01-007] to seal the areas between the rod end bearings
and the actuation lever arm bearings.
(a) It is recommended that the height of the sealant be less than 0.250 (6.35 mm).
SUBTASK 72-35-00-348-062-G00
(5) Let the RTV sealant cure for approximately 12 hours.
NOTE: The cure time is for a room temperature of 77 degrees F (25 degrees C) with 50
percent relative humidity.
SUBTASK 72-35-00-848-063-G00
(6) If no more work will be done at this time, do the task "Put the Airplane to its Usual Condition
After VSV Repairs".
END OF TASK
TASK 72-35-00-308-043-G00
13. Borescope Blending Tool - Repair of the Stage 1-14 HPC Rotor Blades
A. General
(1) This task gives instructions on how to do the borescope blend repair of the stage 1-14 HPC
rotor blades, and the blend limits for the repair.
(2) This task is used to repair the HPC rotor blades that are found to be unserviceable during the
borescope inspection. You can refer to the HPC blade damage repairable limits that follow. The
allowable damage will be removed during the blend repair procedure.
B. References
Reference Title
72-00-00 P/B 201 ENGINE - MAINTENANCE PRACTICES
72-00-00 P/B 601 ENGINE - INSPECTION/CHECK
C. Tools/Equipment
NOTE: When more than one tool part number is listed under the same "Reference" number, the
tools shown are alternates to each other within the same airplane series. Tool part numbers
that are replaced or non-procurable are preceded by "Opt:", which stands for Optional.
767
AIRCRAFT MAINTENANCE MANUAL
CF6-80A SERIES ENGINES
72-35-00
NoC
Page 825
D633T1B7 Aug 22/2017
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ABX 001-007, 011, 012, 016-019, 021, 022, 025, 101,
109, 114, 115, 314-999
To Next Page
Loading...
