January 2012 6.18 Spindles 1007
MP_zeroPosEdge defines the trip dog edge, which defines the spindle stop
position in positive direction of rotation.
MP_zeroPosEdge
Evaluation of the edge
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: zeroOne
Zero-one transition is evaluated.
oneZero
One-zero transition is evaluated.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
MP_stopOnSwitchSpeed defines the speed for positioning at the trip dog. If
you defined the value forStopping in the MP_fastInputType parameter, you
have to enter the positioning speed here.
MP_stopOnSwitchSpeed
Shaft speed for positioning to the trip dog
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: RPM [1/min] with up to 9 decimal places
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
