HEIDENHAIN MANUALPLUS 620 - Page 1008

1008 HEIDENHAIN Technical Manual MANUALplus 620
MP_maxDecSpeedCtrl
Brake ramp for the spindle
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.000 000 000 to 1000 [m/s2] or [1000°/s
2
]
Define a brake ramp for the spindle different from the
acceleration ramp. You usually enter the same value as in
MP_maxAcceleration.
Default: 3 [m/s2] or [1000°/s
2
]
Access: LEVEL3
Reaction: RUN
MP_externRefPulse
Referencing with external reference signal
Available from NCK software version: 597 110-04.
Format: Selection menu
Selection: Off
The reference signal of the connected motor encoder or the
position encoder is used.
spindleRef (X30)
On systems with HSCI, the reference signal at -SP.REF+ and -
SP.REF- of the external PL is evaluated; on systems with
MC 320T or MC 420 the reference signal at input X30 is
evaluated.
Default: Off
Access: LEVEL3
Reaction: RUN