HEIDENHAIN MANUALPLUS 620 Technical Manual

January 2012 6.18 Spindles 1013
MP_limitSpeedAcc
Limit speed for reduction of the acceleration
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: Value in [°/min] or [mm/min] with up to 9 decimal places
Acceleration of the spindle with "broken" acceleration curve:
The parameter sets the absolute limit speed above which the
acceleration is reduced.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
MP_limitSpeedDec
Limit speed for reduction of the braking deceleration
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: Value in [°/min] or [mm/min] with up to 9 decimal places
Braking of the spindle with "broken" deceleration curve:
The parameter sets the absolute limit speed above which the
braking deceleration is reduced.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
MP_limitAccSpeedCtrl
Absolute acceleration. Effective above MP_limitSpeedAcc
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: Value in [m/s
2
] with up to 9 decimal places
Acceleration of the spindle with "broken" acceleration curve:
Specifies the absolute acceleration of the spindle, which
becomes effective above the speed defined with
MP_limitSpeedAcc.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
MP_limitDecSpeedCtrl
Absolute deceleration during braking. Effective above
MP_limitSpeedDec
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: Value in [m/s
2
] with up to 9 decimal places
Braking of the spindle with "broken" deceleration curve:
Specifies the absolute deceleration during braking, which
becomes effective above the speed defined with
MP_limitSpeedDec.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English