HEIDENHAIN MANUALPLUS 620 - Page 11

January 2012 11
6.21 Integrated Oscilloscope................................................................1145
6.21.1 Fundamentals ...................................................................1145
6.21.2 Preparing a recording........................................................1147
6.21.3 Recording signals..............................................................1151
6.21.4 Analyzing the recording.....................................................1154
6.21.5 Saving and loading recordings ..........................................1157
6.21.6
Circular interpolation test with the integrated oscilloscope ... 1158
6.21.7 Configuring the colors of the oscilloscope display............1159
6.22 Diagnosis with the Online Monitor (OLM) .................................1162
6.22.1 Introduction.......................................................................1162
6.22.2 Using the OLM .................................................................1163
6.22.3 Screen layout ....................................................................1165
6.22.4 Group of NC axes..............................................................1168
6.22.5 Group of spindle commands.............................................1188
6.22.6 Group of NC channels.......................................................1190
6.22.7 Hardware group ................................................................1196
6.22.8 Group of drive commands ................................................1209
6.22.9 Auxiliary group ..................................................................1210
6.22.10 PLC group .........................................................................1216
6.22.11 Queue trace ......................................................................1219
6.22.12 Frequent causes of error...................................................1221
7 Machine Interfacing..............................1223
7.1 Display and Operation..................................................................1223
7.1.1 Unit of measurement for display and operation................1223
7.1.2 Conversational language...................................................1225
7.1.3 Expanded menu structure.................................................1228
7.1.4 Access rights to NC files...................................................1230
7.1.5 Code numbers ..................................................................1230
7.1.6 Programming station mode ..............................................1233
7.1.7 Operating modes / control operation in the operating
mode group.......................................................................1236
7.1.8 Control operation in the machining channel......................1241
7.1.9 Error messages and log files.............................................1254
7.1.10 TURNguide – context-sensitive help system
(user documentation)........................................................1278
7.2 Machine Display in the Dashboard..............................................1287
7.2.1 Assigning dashboards to the operating modes.................1289
7.2.2 Configuring dashboards ....................................................1292
7.3 PLC Soft Keys ................................................................................1307
7.3.1 Soft-key resource file........................................................1308
7.4 Switching the Control On/Off......................................................1313
7.4.1 Powering up the control....................................................1313
7.4.2 Shutting down the control ................................................1317
7.5 Keystroke Simulation ...................................................................1325
7.5.1 Control keyboard...............................................................1325
7.5.2 Machine operating panel...................................................1331