January 2012 6.21 Integrated Oscilloscope 1155
Changing the
display
The following soft keys influence the entire display range (all signals):
Shift the display range to the left.
Shift the display range to the right.
Decrease horizontal resolution.
Increase horizontal resolution.
Increment The increment used when shifting the display or shifting the cursor is shown
in the status field at bottom left, with the code "sk: ....." (see the "cursor
information" illustration).
The Page Up key increases the increment, and the Page Down
key decreases it.
Analyzing an
individual analog
signal
Use the arrow up and arrow down keys to select the channel
to be analyzed.
The selected channel is indicated with an asterisk (*). At the same time, the
cursor is activated and placed on the selected channel.
Shown in the status field (bottom left) are (see "cursor information" figure):
Code "t1: .....": Cursor position in [s], referenced to t0
Code "Cu1: .....": Signal size at the cursor position
Shifting the cursor:
Shift the cursor with the right arrow and left arrow keys.
To Next Page
Loading...
