HEIDENHAIN MANUALPLUS 620 - Page 1186

1186 HEIDENHAIN Technical Manual MANUALplus 620
Switching the
parameter set of an
axis (Change
ParSet)
The active parameter set of an axis can be switched for test purposes.
To select the Change ParSet function:
 Press the Login Ipo (or Login SimIpo) soft key.
 Press the Axes soft key.
 Press the Change ParSet soft key for the OLM to open the
"Change ParSet" dialog box.
 Enter the required data in the dialog box (see below).
 Confirm with OK—the OLM switches to the defined
parameter set.
"Change ParSet" dialog box:
Dialog box entries:
 Axis-Index: Logical axis number
 ParSet-Index: Index of parameter set