1212 HEIDENHAIN Technical Manual MANUALplus 620
Reload of trace
information
The configuration data for the IPO trace is loaded from the configuration file
O:\service\traceInfo.cfg.
To select the Check AxPar function:
Press the Login Ipo (or Login SimIpo) soft key.
Press the Auxil soft key.
Press the Reload TraceInfo soft key for the OLM to load the
configuration data.
M97-G62-G162 Outputs during the synchronization of several NC
channels (not relevant for MANUALplus 620)
AxesRegState Outputs at status change of axes in the controller
ServerLogin Log in to / log out of the IpoData server
Graphics Request of workpiece positions for the on-line graphics
and graphic simulation
CC Watchdog Not used
Threading Outputs during thread cutting
GAL Not used
LiftOff Lift off of tool during cycle stop
AxisPolys Trace of the distance polynomials (result in file
_HelpTrace.txt)
HirthAxis Outputs during Hirth axis commands
DrvCmdData Reserved
EthernetAll Reserved
PathNames Output of the names of all selected programs and
cycles, including the paths
Watchdog Output of watchdog states (only output once)
EthNet OnOff Reserved
Terminal Enable output to serial terminal
GetValues Output when capturing positions with internal path
calculation
Encoder Reserved
RequestedPos Output when approaching the restore position
Variable Display
To Next Page
Loading...
