January 2012 7.2 Machine Display in the Dashboard 1303
Attribute=0 (bit 0=0)
Attribute=1 (bit 0=1)
Attribute=2 (bit 1=1)
Cycle OFF
SlideAndFeed
RateInformation
[DB_CH1_
STATE]
Display: Slide number, slide status (cycle
ON/OFF), feed rate and override. If the
slide is idle, the programmed feed rate is
displayed in gray.
Attributes:
Bit 0=0: Display the actual feed rate and
the override value
Bit 0=1: Display the programmed feed
rate and the actual feed rate
Bit 1=1: Display the programmed feed
rate, the actual feed rate and the
override value
The ballscrew being used to calculate the
contouring feed rate is displayed above the
slide symbol.
If rear-face machining is enabled, the slide
number is highlighted in blue.
Attribute=0 (bit 0=0)
Attribute=2 (bit 1=1)
Attribute=4 (bit 2=1)
Displayed as of SW04
ChannelDisplay
[DB_OVERRIDE]
Display: Override for F, S and R
Attributes:
Bit 0=0: S at left, F or R at right
Bit 0=1: F or R at left, S at right
Bit 1=0: Display of feed override F
Bit 1=1: Display of rapid traverse
override R
Bit 2=0: Display of feed override F
Bit 2=1: Display of rapid traverse
override R + feed override F
Bit 3= 1: Display of the selected spindle
As of NC software version 04, the channel
number and the configured spindle name
are displayed in addition.
Image Name Display/Attribute
To Next Page
Loading...
