HEIDENHAIN MANUALPLUS 620 - Page 1304

1304 HEIDENHAIN Technical Manual MANUALplus 620
Utilization display of the spindle
Utilization display of an axis
Attribute=2 (bit 1=1)
Utilization display showing the
rotational speed limiting (only for
spindles). The configured spindle
name is displayed, as well.
LoadDisplay
[DB_LD_C1,
DB_LD_S1,
DB_LD_X1,
DB_LD_Z1]
Display: Utilization of the drive of an axis
(spindle, X, Z and C axes)
Attributes:
 Bit 0=0: Digital drive; display data is
supplied by the CC
 Bit 0=1: Analog drive; display data is
supplied by the user PLC
 Bit 1=0: Without display of rotational
speed limiting
 Bit 1=1: With display of the rotational
speed limiting (only for spindles)
 Bit 3= 1: Display of the selected spindle
Display of unit quantities and
time per unit
Display of unit quantities
QuantityInformati
onAndTimePerU
nit
[DB_WPCT1]
QuantityInformati
on
[DB_WPC1]
Display: Unit quantities and time per unit
MP: Default unit quantity
P: Number of finished parts
t: Time in current program
St: Total time
Display: Unit quantity
MP: Default unit quantity
P: Number of finished parts
The quantity is incremented after each
M30, M99 or M18 programmed counter
pulse.
Image Name Display/Attribute