HEIDENHAIN MANUALPLUS 620 - Page 1334

1334 HEIDENHAIN Technical Manual MANUALplus 620
Type of handwheel MP_type
Handwheel
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: NONE
No handwheel connected
HRNAX
HRA 110 handwheel adapter connected to X23
HR410
HR 410 connected to X23
HR332
HR 332 connected to X23
HR330
HR 330 connected to X23
HR130
HR 130 connected to X23
Default: NONE
Access: LEVEL3
Reaction: RUN
Handwheel
initialization
You enter initialization values for serial handwheels in MP_initValues. During
startup, the control transfers the initialization values to the handwheel.
Information about the initialization values:
 HR 410: see "HR 410 portable handwheel" on page 1348
 HR 130: No initialization values are necessary for this model
 HRA 110 with HR 150: see "HR 150 panel-mounted handwheels with HRA
110 handwheel adapter" on page 1350
MP_initValues
Initialization values for handwheel
Available from NCK software version: 597 110-01.
Format: Array [7]
Input: 0 to 255
Default: 0
Access: LEVEL3
Reaction: RUN