January 2012 7.11 Additional Parameters for Lathes 1409
Cycle selection in
Program Run
When selecting the Program Run mode, until now the first cycle in a cycle
program was always selected, regardless of the cycle selected in teach-in.
This behavior can now be changed via the MP_ncStartWithActCyc machine
parameter insofar as the cycle selected last is confirmed when changing from
Teach-in to Program Run.
MP_ncStartWithActCyc
Program run with the most recently selected cycle
Available from NCK software version: 597 110-05.
Format: Selection menu
Selection: On
When Program Run is selected, the most recently selected
cycle remains active
Off
When switching to Program Run, the first cycle of the cycle
program is always selected.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
Settings in the configuration editor MP number
Aggregates
General
CfgGlobalProperties
ncStartWithActCyc 601809
To Next Page
Loading...
