January 2012 7.11 Additional Parameters for Lathes 1413
Module 9481 Find the channel display
The module provides the active and the selected channel display of an
operating panel.
Call:
PS B/W/D/K <Operating panel>
0: At present only one user interface possible
CM 9481
PL D <Index of the active channel used by the user interface>
1: No active channel present
PL D <Index of the selected channel that was preset by the PLC>
1: No selected channel present
Error recognition:
Module 9482 Select the spindle display
On controls that support multiple channels, this module makes it possible to
control the display of spindle data. In addition, user entries (e.g. through dialog
menus) for a selected spindle can also be enabled. The module selects the
program spindle for the selected operating panel. There is no explicit response
time by which this request is accepted by the operating panel. The execution
of this module can be monitored with Module 9483.
Call:
PS B/W/D/K <Operating panel>
0: At present only one user interface possible
Bit 0: Display of spindle data
Bit 1: Entry of spindle information
PS B/W/D/K <Logical spindle number>
CM 9482
PL D <Error code>
0: New spindle display selected
1: Addressed operating panel not in permitted range
2: Addressed spindle not in permitted range
3: Action not valid
4: Operating panel not designed for switchable channel
display
5: Module not executed, as switchover already active for
operating panel
Marker Value Meaning
NN_GenApiModule
Error (M4203)
0No error
1 Addressed operating panel not in permitted
range
2 Addressed operating panel not designed
for switchable channel display
To Next Page
Loading...
