January 2012 7.12 Configuration of the Lathe 1445
Tool change with
active Y axis
Use MP_doProgAfterTCall to define whether a subprogram is to be run after
a tool change so that the Y axis moves to position Y=0. The expert program
_tcall1.ncs is used as subprogram by default (see "Expert programs" on page
1476).
MP_doProgAfterTCall
Run subprogram _tcall1.ncs after the tool change
Available from NCK software version: 597 110-04.
Format: Selection menu
Selection: TRUE
The subprogram _tcall1.ncs is run after the tool change
FALSE
No subprogram is run after the tool change
Default: -
Access: LEVEL3
Reaction: RUN
Deactivating the Y
axis
If you want to remove the Y axis from the configuration of your machine, you
must follow the above-described procedure in reverse order.
Settings in the configuration editor MP number
Aggregates
General
CfgGlobalProperties
doProgAfterTCall 601806
To Next Page
Loading...
