HEIDENHAIN MANUALPLUS 620 - Page 1447

January 2012 7.12 Configuration of the Lathe 1447
Configuring the
parallel axes
(U, V, W)
Make the following changes if your machine is to be operated with a U, V or
W axis:
 Switch to the Organization mode of operation.
 Press the soft key.
 Enter the code number 95148.
 Press the CONFIG FILE LISTS soft key.
 Enter the axis_u1.cfg, axis_v1.cfg and axis_w1.cfg files in the dataFiles
list in CfgConfigDataFiles.
 Define the type of parallel axis (linear axis, rotary axis) in MP_progKind, see
"MP_progKind" on page 629. The direction of movement of the parallel axis
can also be defined in CfgProgAxis with MP_dir, see "MP_dir" on page 628.
The MANUALplus 620 supports various methods for treating movements of
parallel axes, see "Parallel Axes" on page 762. Please note that option 94
"Parallel Axes" is only required for automatic position compensation in the
principal axis for movements of the parallel axis (MP_parAxComp =
Display).
 Now add the parallel axes (U, V, W) to the axisList in CfgAxes. To do so,
press the MORE FUNCTIONS soft key, then the INSERT soft key and select U1,
V1, W1 in the pop-up window.
Settings in the configuration editor MP number
CfgConfigDataFiles
dataFiles
...
[..]: %oemPath%\axis_u1.cfg
[..]: %oemPath%\axis_v1.cfg
[..]: %oemPath%\axis_w1.cfg
...
106303
Settings in the configuration editor MP number
System
CfgAxes
axisList
[0]: X1
[1]: Z1
[2]: U1
[3]: V1
[4]: W1
[5]: S1
[6]: S2
100001