January 2012 7.12 Configuration of the Lathe 1459
The specWpSpindleList located in CfgRearSideKinem contains the key
names of all workpiece spindles with special transformations for rear-side
machining.
The mirAxis list located in CfgRearSideTrafo contains the key names of all
mirrored axes for rear-side machining. The transformations for mirroring the
axes entered here are listed in trafoMirAxis. The transformation is assigned
to the axis through the list index. The transformation for mirroring the Z1 axis
is named Trans_A180 and is performed counterclockwise so that the
direction of the X axis and Y axis is maintained and only the Z1 axis is rotated
by 180°. The transformation for tool length mirroring in the Z direction with
the lists toolLengthDir and trafoMirToolLength is currently not yet
available.
Settings in the configuration editor MP number
Aggregates
RearSideMachining
CfgRearSideKinem
[Key name of the machining channel]
specWpSpindleList
[0]: S4
605702
Settings in the configuration editor MP number
Aggregates
RearSideMachining
CfgRearSideTrafo
[Key name of the workpiece spindle for
RSM]
mirAxis
[0]: Z1
trafoMirAxis
[0]: Trans_A180
toolLengthDir
[0]: ...
trafoMirToolLength
[0]: ...
605804
605801
605805
605802
To Next Page
Loading...
