HEIDENHAIN MANUALPLUS 620 - Page 1460

1460 HEIDENHAIN Technical Manual MANUALplus 620
 The zeroPointOffsAxis list located in CfgRearSideTrafo contains the key
names of the axes with datum shift. The transformations for the datum shift
of the axes entered here are listed in the zeroPointOffset list. The
transformation for the datum shift is assigned to the axis through the list
index. The transformation for the datum shift of the Z1 axis is named
Trans_Z1 and is contained in the zeroPointOffset list.
 The kinematics group for rear-side machining with the opposing spindle S4
is activated with the G function G30 Q4. When the program is canceled or
finished, the currently active kinematics for rear-side-machining remains
active at first and is only deactivated when a new program is selected in
Program Run or when the control is restarted.
Settings in the configuration editor MP number
Aggregates
RearSideMachining
CfgRearSideTrafo
[Key name of the workpiece spindle for
RSM]
zeroPointOffsAxis
[0]: Z1
zeroPointOffset
[0]: Trans_Z1
605806
605803