January 2012 7.12 Configuration of the Lathe 1463
MP_trafoMirToolLength
Transformation for mirroring the tool length
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: For the directions located in MP_toolLengthDir , enter here the
transformations for mirroring the tool lengths. The
transformation is assigned to the direction of the mirrored tool
length through the list index.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
MP_zeroPointOffsAxis
List with the key names of the axes with datum shift
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: For the axes entered in this list, enter the transformations for
the datum shift in "MP_zeroPointOffset . The transformation
for the datum shift is assigned to the axis through the list index.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
MP_zeroPointOffset
List of the datum shifts of the axes
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: For the axes located in MP_zeroPointOffsAxis , enter the
transformations for the datum shift in this list. The
transformation for the datum shift (zero-point offset) is assigned
to the axis through the list index.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
To Next Page
Loading...
