1462 HEIDENHAIN Technical Manual MANUALplus 620
MP_kinList
List of the key names of all kinematics for rear-side machining
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: Enter the key names of all kinematics for rear-side machining in
this list.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
MP_specWpSpindleList
List of the key names of all workpiece spindles for rear-side
machining
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: Enter the key names of all workpiece spindles with special
transformations for rear-side machining in this list.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
MP_mirAxis
List with the key names of the mirrored axes
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: For the axes entered here, enter the transformations for
mirroring in MP_trafoMirAxis. The transformation is assigned
to the axis through the list index.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
MP_trafoMirAxis
List of the key names of the transformations for axis mirroring
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: For the axes located in MP_mirAxis, enter here the
transformations for mirroring the axes. The transformation is
assigned to the axis through the list index.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
MP_toolLengthDir
List with the axis directions of the mirrored tool lengths
Available from NCK software version: 597 110-05.
Format: Array [0...100]
Input: Enter the transformations for mirroring the tool lengths in
MP_trafoMirToolLength. The transformation is assigned to
the direction of the tool length through the list index.
Default: No value, parameter optional
Access: LEVEL1
Reaction: RUN
To Next Page
Loading...
