HEIDENHAIN MANUALPLUS 620 - Page 1471

January 2012 7.12 Configuration of the Lathe 1471
 Check the description, and add the dimensions of the tool carrier
TH1_MULTI (see "Tool carriers" on page 1396) and the tool holder
TH1_TM001_MULTI (see "Tool holders (mounts)" on page 1400).
Tool turret The tool carrier TH1_REV is already configured in the standard configuration.
 In the two entities listed below, enter the key name TH1_REV for the tool
turret.
Settings in the configuration editor MP number
Aggregates
ToolHolder
TH1_MULTI
CfgTHDescription
ordinalNr
. . .
Aggregates
ToolMount
TH1_TM001_MULTI
CfgToolMount
mountPosWAPP
. . .
600200
600203
. . .
600400
600401
. . .
Settings in the configuration editor MP number
Channels
ChannelSettings
CH_NC1
CfgAssignAggregate
assignToolHolder
[0]: TH1_REV
Aggregates
General
CfgAggregateKeys
toolHolderKeys
[0]: TH1_REV
203901
600001