1578 HEIDENHAIN Technical Manual MANUALplus 620
MP_toolIndex
Symbolic name or number of the PLC word for transmitting the
tool index
Available from NCK software version: 597 110-01.
Format: String
Input: Max. 80 characters
Name of the PLC word in which the tool index is transmitted to
the PLC
Default: No value, parameter optional
Access: LEVEL3
Reaction: RESET
MP_toolMagazine
Symbolic name or number of the PLC word for transmitting the
magazine number of the tool
Available from NCK software version: 597 110-01.
Format: String
Input: Max. 80 characters
Name of the PLC word in which the magazine number of the
tool is transmitted to the PLC
Default: No value, parameter optional
Access: LEVEL3
Reaction: RESET
MP_pocketNumber
Symbolic name or number of the PLC word for transmitting the
pocket number of the tool
Available from NCK software version: 597 110-01.
Format: String
Input: Name of the PLC word in which the pocket number of the tool
is transmitted to the PLC
Default: No value, parameter optional
Access: LEVEL3
Reaction: RESET
MP_unloadTool
Symbolic name or number of the PLC marker that is set during
decoding if no tool is loaded
Available from NCK software version: 597 110-03.
Format: String
Input: Max. 80 characters
The definition of this marker is not necessary if the T0 and T1
strobes are otherwise distinguished.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RESET
To Next Page
Loading...
