1592 HEIDENHAIN Technical Manual MANUALplus 620
System tables The write-protected directory SYS:\table contains the control's system
tables.
In the conv1.hc table, converted G and M functions are assigned to the
original G and M functions (e. G. for rear-side machining). The conversion list
is assigned to a tool holder by entering the number of the conversion list in
MP_convTblNr (e.g. MP_convTblNr = 1 for conv1.hc).
The inverter.inv table contains important parameters of the power modules
(see "Entries in the power module table (inverter.inv)" on page 1078).
The supply.spy table contains important parameters of the supply modules
(see "Entries in the power supply module table: (supply.spy)" on page 1077).
JhNcError.pet error message table
The HEIDENHAIN standard motor table, MOTOR.MOT, contains important
motor parameters (see "Entries in the motor table (motor.mot)" on page
1078).
The power module table of older HEIDENHAIN contouring controls,
motor.amp, is no longer supported by the control!
Table name Group Meaning
conv1.hc SYS Heidenhain conversion list for M and
G functions
inverter.inv Power module table
JhNcError.pet PLC error message list
MOTOR.MOT Motor data
simu.hsi Colors, chucking equipment (not for
MANUALplus 620)
supply.spy Supply module table
To Next Page
Loading...
