HEIDENHAIN MANUALPLUS 620 - Page 28

28 HEIDENHAIN Technical Manual MANUALplus 620
Machine
parameters
new/enhanced/
modified
Enhanced/Modified machine parameters:
MP number Config object Parameter Description of change
100201 CfgMachineSimul MP_simMode  When the new value Delivery is
set, during startup of the control all
axes are set to the test mode, and a
switch-on of the axes is prevented.
The user should then be able to
start the control, even with an
incomplete or faulty axis
configuration in order to put the
axes into operation. After the
configuration of all axes has been
completed, the control can be
switched to full operation
(FullOperation).
 If Delivery, CcAndExt or CcOnly is
set, the control now no longer
outputs any analog nominal values.
102902 CfgFileType MP_standardEditor "TEXT-EDITOR" can now be selected
in order to assign the ASCII editor of
the control to a file type.
103502 CfgPlcTimer MP_value The input range of the parameter was
expanded from 1 000 to 1 000 000
seconds (corresponds to approx. 11.5
days).
104300
104400
CfgPlcOverrideDev
CfgPlcOverrideS
– The reaction of the parameters under
CfgPlcOverrideDev, CfgPlcOverrideS,
CfgPlcOverrideF and
CfgPlcOverrideR was changed from
NOTHING to RESET. The control
must now be rebooted after a
parameter change.
105201 CfgSystemTime MP_offsetToUTC Values with decimal places can now
be entered for time differences to
universal time (GMT). This is
necessary for parts of Australia
(+8.5 and +9.5 hours) and Kazakhstan
(+3.5 hours), for example. Also, the
maximum value was extended from
+13 to +14 [hours].
400011 CfgAxisHardware MP_posEncoder
Resistor
The default value of the parameter
was changed from without to
120 ohm.