HEIDENHAIN MANUALPLUS 620 - Page 29

January 2012 1.2 NC Software 548 328-02 29
New machine parameters:
MP
number
Config object Parameter Description
102907 CfgFileType MP_protect Disables filtering or editing of a file
type, see page 1597.
104018 CfgPlcSStrobe MP_cuttingSpeed Optional parameter – If parts of the
configuration indicate the symbolic
name or number of a word marker
to which the cutting speed is
copied.
104304 CfgPlcOverrideDev MP_mop In MP_mop, enter the key name of
the machine operating panel on
which the override source is
located, see page 1353.
106501 CfgConfigSettings MP_undoListSize Defines the number of entries in
the parameter change list, see
page 339.
106502 MP_suppressUsrMsg This parameter is used to suppress
the warning Key non-functional,
see page 1277.
106503 MP_dispParam
Numbers
Specifies whether MP numbers or
symbolic names are displayed in
the parameter change list, see
page 339.
106504 MP_hideWrite
Protected
If the parameter is set to TRUE,
write-protected parameters are
hidden in the configuration editor,
see page 350.
116103 CfgPlcSymName MP_dbLoadDisplay The parameter defines the variable
name for the dashboard load
display, see page 1405.
203804 CfgChannelProperties MP_kinManualMode Y axis as oblique axis: Activate the
compensating motion in Manual
mode as well, see page 1444.
300110 CfgAxis MP_deactivatedAtStart Deactivate the axis or spindle
during start-up, see page 682.
300111 MP_restoreModuloCntr Save modulo counter of the axis in
SRAM, see page 632.
300205 CfgAxisPropKin MP_parAxComp Define the compensation for
parallel secondary axes, see page
762.
401509 CfgSpindle MP_changeTurnDir Rotational direction reversal with
M3 and M4, see page 663.
601801 CfgGlobalProperties MP_lifeTime Activate tool life monitoring for tool
service age or workpiece quantity,
see page 1408.
601806 CfgGlobalProperties MP_doProgAfterTCall Run subprogram after the tool
change, see page 1445.