340 HEIDENHAIN Technical Manual MANUALplus 620
You can specify which areas of the machine configuration are to be searched.
This is done by ticking the respective area on the left-hand side of the dialog
box. You can also select more than one area at the same time for searching.
The following possibilities for searching are available:
If the machine configuration has been searched down to the end or up to the
beginning (depending on the search direction) and the search term has not
been found, the control inquires whether the search is to be continued in the
direction opposite to the selected one.
Selection Function
Names Search for object and parameter names.
You can also enter just a part of the text to be searched for as
search criteria in the Find text: field. The CURRENT WORD
button and soft key load the term marked with the cursor into
the search field. The search term can be written in capitals or
small letters.
Numbers Search for an MP number. You can also enter just part of the
number to be found.
MP number Search for the compatible iTNC MP number. In many
parameters the parameter number of the iTNC 530 contouring
control is displayed in the help text. After this function is
selected and an iTNC parameter number is entered, the
configuration is searched for equivalents.
Values Search for certain parameter values.
As soon as you have selected the Values function, the
Replace with: input field becomes active.
By entering a value in the "Replace with" field, you can change
the string found by pressing the REPLACE soft key. This
replacement only affects the current search hit.
Key name Search for a certain key name.
As soon as you have selected the Key name function, the
Replace with: input field becomes active.
By entering a value in the "Replace with" field, you can change
the string found by pressing the REPLACE soft key. This
replacement only affects the current search hit.
Comment Search for certain user comments. (see "User comment" on
page 341.)
To Next Page
Loading...
