40 HEIDENHAIN Technical Manual MANUALplus 620
Overview of the
improvements
A summary of the improvements in NC software 548 328-03 is given below.
For more detailed information, please refer to the Technical Manual sections
indicated in the brief descriptions given below.
Machine
configuration
New: HSCI/PROFIBUS diagnostics
After the OEM code word has been entered, the BUS DIAGNOSIS soft key
will now be available in the Organization mode of operation after pressing
the DIAGNOSIS soft key. The arrangement of all bus participants as well as
the properties and conditions of each individual device are displayed
graphically and separately for HSCI and Profibus, See "Bus diagnosis" on
page 1502.
Implementation of new kinematic model
The new kinematic model developed for NCK-based controls is now also
available for the MANUALplus 620. The new kinematic model makes it
possible to use the PC software KinematicsDesign to create and modify
kinematic configurations, See "Machine Kinematics (As of NC Software
548328-03)" on page 727.
Enhanced: OEM cycles with dialog texts and help graphics
The OEM can define his own cycles (G500 to G590) with dialog texts and
help graphics. A prepared file in XML format is available as a template in the
control under PLC:\resource\formdlg\g_oem.fdxml See "OEM cycles
(G5xx)" on page 1588.
Enhanced: PLC G functions with dialog texts and help graphics
Dialog texts with help graphics can now be saved in the control for G
functions (G602 to G699) that are not executed in a subprogram, but by the
PLC, See "PLC-G functions (G6xx)" on page 1588.
Enhanced: Creating subprograms
When subprograms are written, a separate help graphic can now be defined
and displayed for every input field in the dialog.
Enhanced: Update rules for OEM parameters
In the directory PLC:\config\lathe\manplus, release-specific files were
provided for the update rules of the machine tool builder.
In the control's shipping condition, the UpdateOemRe100x.cfg files
(update rules for release x) are empty.
To Next Page
Loading...
