January 2012 1.2 NC Software 548 328-03 41
Machine
parameters
new/enhanced/
modified
Enhanced/Modified machine parameters:
New machine parameters:
MP number Config object Parameter Description of change
100402 CfgFilter MP_typeFilter1 The input range for the maximum
value of the filter order was increased
from 31 to 63.
100404 MP_typeFilter2
113102 CfgDashboardElem
nt
/DB_LD_S1
/DB_LD_S2
MP_attribut For spindles, the utilization of the
rotational speed limit can be displayed
by setting bit 1 = 1 in MP_attribut;
See "Configuring dashboards" on page
1292.
113102 CfgDashboardElem
nt
/DB_OVERRIDE
MP_attribut In the override display of the
dashboard, the current rapid traverse
reduction can be displayed by setting
bit 1 = 1 in MP_attribut; See
"Configuring dashboards" on page
1292.
MP
number
Config object Parameter Description
116104 CfgPlcSymName MP_readTsfData The data for feed rate and spindle
speed can now be read out by the
PLC from the "Set T, S, F" dialog; See
"Transferring the spindle speed and
feed rate data to the PLC" on page
1406.
116105 MP_displayMode The active display mode (e.g. "manual
control," and "automatic") can now be
passed on to the PLC; See "Transfer
display mode to PLC" on page 1406.
116106 MP_setToolPlace By entering a PLC operand, the PLC
can command the turret position,
which you would otherwise have to
set manually; See "MP_setToolPlace"
on page 1407.
To Next Page
Loading...
