January 2012 4.10 List of Machine Parameters 443
split
103908
(optional parameter)
The M function is split into the specified M
functions
The currently active M function can be split into
the two specified M functions. You can cancel it in
part by canceling one of the specified M
functions. The currently active M function is split
up if part of it is canceled by the MP_revoke
parameter.
Example: M13 = Spindle ON clockwise (M3) +
coolant ON (M8)
If function M13 is active and an M5 is collected
during the block scan, for example, the function
M3 contained in M13 is canceled. Only function
M8 remains active. In this case, enter 3 and 8 in
the parameter.
Format: List [2] with numerical values
Input: Numbers of M functions
RESET
LEVEL3
1553
group
103915
(optional parameter)
Group ID
After the block scan, the collected M functions are
implemented in the order of their group IDs
(starting from the lowest).
Format: Numerical value
Input: 0 to 2147483647
RESET
LEVEL3
1553
track
103914
(optional parameter)
Automatic tracking of the active M functions
Normally the PLC program has to use the module
9088 to track the status of the active M function.
Set this parameter to TRUE if the PLC run-time
system is to implement the status automatically.
Format: Selection menu
Input:
TRUE:
The status of the active M function is tracked
automatically, depending on the
MP_trackMState parameter (CfgPlcOptions).
FALSE:
The status of the active M function must be
tracked by calling Module 9088.
RESET
LEVEL3
1553
Parameter
MP number
iTNC MP number
Function and input Behavior
Access
SW vers.
Page
To Next Page
Loading...
