HEIDENHAIN MANUALPLUS 620 - Page 497

January 2012 4.10 List of Machine Parameters 497
ChannelSettings
Channel-specific settings
[Key name of the machining channel]
Two channels are permanently defined:
 CH_NC: Machining channel
 CH_SIM: Simulation channel
CfgChannelAxes
Definition of the axes and axis names of this channel
progAxis
200301
Programmable axes
Programmable axis names and axis names for the
position display in the workpiece system.
Format: Array [0 to 8]
Input: Selection of key names from
CfgAxes/axisList
RESET
LEVEL3
618
refAxis
200303
Axes that are to be run over the reference
point
Defines the axes that are to be referenced and the
reference order.
Format: List [0 to 6]
Input: Selection of key names from
CfgAxes/axisList
RESET
LEVEL3
621
refAllAxes
200304
(optional parameter)
Homing all axes in succession after an NC
START
Format: Selection menu
Input:
 TRUE:
Traverse the reference mark of all axes in
succession after an NC START.
 FALSE:
A reference run is not performed for all axes
Default: FALSE
RESET
LEVEL3
621
restoreAxis
200305
(optional parameter)
Sequence for returning to the contour
Specifies the sequence in which the axes are
returned to the contour after NC stop or during
block scan. After NC stop, the axes are moved to
the stop position. During a block scan, they are
moved to the calculated restore position.
Format: List [0 to 6]
Input: Selection of key names from
CfgAxes/axisList
RESET
LEVEL3
623
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page