HEIDENHAIN MANUALPLUS 620 - Page 499

January 2012 4.10 List of Machine Parameters 499
CfgActivateKinem
Active machine kinematics;
A certain kinematic configuration can be activated with this entry.
kinemToActivate
204001
Kinematics to be activated / Active kinematics
Define here the key name of the kinematic
configuration to be activated. You can also see
from this parameter which kinematics
configuration is currently active.
Format: Selection menu
Input: Key name of the kinematics model
from CfgKinComposModel
RUN
LEVEL3
738
CfgChannelFile
Definition of the initialization files for this channel;
Specifies the paths of system cycles of the geometry calculation, for example.
The parameters are predefined by HEIDENHAIN and should not be changed.
geoChainInit
200401
Path/name of the file for initializing the
geometry chain
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
geoIniProgram
200402
Path/name of the lead program for program
run
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
geoIniBlock
200403
Path/name of the lead program for MDI mode
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
geoIniCycle
200404
Path/name of the lead program for manual
cycles
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
geoCycleEnd
200405
Path/name of the trailing program for
program end
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
geoCancelCycle
200406
Path/name of the trailing program if program
aborts
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
geoTCallCycPath
200407
Path/name for the TOOL CALL cycle
Format: String
Input: Max. 260 characters
RESET
LEVEL3
–
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page