HEIDENHAIN MANUALPLUS 620 - Page 578

578 HEIDENHAIN Technical Manual MANUALplus 620
Settings
Lathe-specific parameter sets for the axes
LinearAxis
Lathe-specific parameter sets for linear axes
[Key name of the linear axis]
CfgAxisProperties
Defines the lathe-specific characteristics of the existing linear axes
threadSafetyDist
300902
Approach path for the thread start
When starting a thread, the programmed feed
rate must be attained within the approach path.
Format: Numerical value
Input: Approach path in [mm] with up to
9 decimal places
Default: 3
RUN
LEVEL3
1389
CfgProtectionZone
Positive and negative value for defining the protection zone
limitPositive
301001
Positive protection zone
Positive limit value for the protection zone.
Format: Numerical value
Input: Positive limit value for the
protection zone [mm]
with up to
9 decimal places
0: No monitoring of protection zone
Default: +999999999 [mm]
RUN
LEVEL3
1390
limitNegative
301002
Negative protection zone
Negative limit value for the protection zone.
Format: Numerical value
Input: Negative limit value for the
protection zone [mm]
with up to
9 decimal places
0: No monitoring of protection zone
Default: –999999999 [mm]
RUN
LEVEL3
1390
Parameter
MP number
iTNC MP number
Function and input Reaction/
Access
Page