64 HEIDENHAIN Technical Manual MANUALplus 620
Machine
parameters
new/enhanced/
modified
Enhanced/Modified machine parameters:
MP
number
Config object Parameter Description of change
100103 CfgHardware MP_currentControlAdjust The parameter was removed from
the machine configuration.
100401 CfgFilter MP_typeFilter1 The parameter was removed since
as of NCK-SW 597 110-05 there are
new MPs for configuration of the
nominal position value filters, see
page 814.
100402 MP_orderFilter1
100403 MP_typeFilter2
100404 MP_orderFilter2
102307 CfgPlcPath MP_compErrorTable The machine parameter was
removed from the configuration.
The path for the error table of the
PLC compiler has now been
permanently set to
SYS:\config\plccomp.ert by
HEIDENHAIN and cannot be
configured anymore.
104701 CfgOemPosition MP_value The new ACTUAL POSITION
CAPTURE soft key is available for
the parameters for configuring OEM
position values. The soft key
displays a soft-key row showing the
available axes. If you press an axis
soft key, the MANUALplus 620
adopts the position of the axis from
the REFNOML system, see page
1657.
400013 CfgAxisHardware MP_inverterInterface The MP_pwmSignalOutput
parameter was renamed to
MP_inverterInterface, see page
657.
400016 CfgAxisHardware MP_checkPhiFieldRef The parameter
MP_checkPhiFieldRef was
removed.
400305 CfgFeedLimits MP_maxAcceleration The configurable minimum value
was set to 0.000000001 m/s
2
.
400501 CfgPositionLimits MP_swLimitSwitchPos The new ACTUAL POSITION
CAPTURE soft key is available for
the parameters for configuring the
software limit switches. The soft
key displays a soft-key row showing
the available axes. If you press an
axis soft key, the MANUALplus 620
adopts the position of the axis from
the REFNOML system, see page
688.
400502 MP_swLimitSwitchNeg
To Next Page
Loading...
