January 2012 1.3 NC Software 548 328-04 65
401001 CfgCurrentControl MP_iCtrlPropGain Automatic calculation of the P and I
factor of the current controller is
now possible for synchronous and
asynchronous motors. However,
automatic calculation is not to be
used for linear synchronous and
torque motors. The calculated value
is entered in the configuration. An
asterisk (*) is prefixed to the
parameters to identify the
automatically calculated value, see
page 885.
401002 MP_iCtrlIntGain
401202 CfgPowerStage MP_ampPowerSupplyType The parameter was removed from
the machine configuration. It is no
longer necessary, because the
value is now read from the power
supply module table SUPPLY.SPY.
401205 MP_ampVoltProtection Defines the setting for field
weakening for synchronous motors.
The parameter was revised to
provide new modes for field
weakening. For the chapter dealing
with information on weakened-field
operation, please refer to
“Weakened field operation" on page
924.
MP
number
Config object Parameter Description of change
To Next Page
Loading...
