HEIDENHAIN MANUALPLUS 620 - Page 66

66 HEIDENHAIN Technical Manual MANUALplus 620
New machine parameters:
MP
number
Config object Parameter Description
100204 CfgMachineSimul MP_simHardwareType Defines the simulated CC in the
programming station mode, see
page 1235.
100405
100406
CfgFilter MP_shape The nominal position value filters
were thoroughly revised and
optimized (See "Configuration of
the nominal position value filters
as of NCK software version
597 110-05" on page 814).
100405
100406
MP_frequency
100405
100406
MP_hscMode
100407 MP_defaultManualOrder
100610 CfgHandwheel MP_selectAxes Selection of the axis/axes that are
to be moved by the handwheel
configured in MP_type, see page
1338.
102315 CfgPlcPath MP_pythonScripts Specifies which Python scripts
are automatically started after
compilation of the PLC program,
see page 1545.
102502 CfgTablePath MP_readOnlyMode Activates write-protection for the
respective table in the table
editor.
118301 CfgPythonScript MP_parameter Specifies expanded calling
parameters for the Python script,
see page 1585.
118302 MP_memLimit Specifies the maximum memory
available for the Python
application to be started, see page
1585.
118303 MP_path When the soft key entered in the
key name is pressed, the selected
Python script is started, see page
1585.
118304 MP_jobName Specifies the name of the Python
application, see page 1585.
120501 CfgChangePassword MP_replaceWith Replaces existing HEIDENHAIN
code numbers with the OEM's
own code numbers, see page
1231.
120502 MP_hideOriginal
201516 CfgLaPath MP_reduceCornerFeed Reduction of the contouring feed
rate at the beginning of a contour
element, see page 836.
300112 CfgAxis MP_advancedSettings Specifies advanced settings for
individual axes, see page 638.