680 HEIDENHAIN Technical Manual MANUALplus 620
The following table shows the assignment of available and configurable
monitors of the axes to the various activation statuses.
Switching
parameter sets
If you also switch parameter sets (e.g. when exchanging milling heads) when
activating or deactivating axes over the PLC, you have to observe particular
conditions (see "Switching Parameter Sets" on page 398).
Activation status Monitoring active Monitoring inactive
Closed-loop axis Following error monitoring
Standstill monitoring
Movement monitoring
Monitoring of the amplitude of
the encoder
Monitoring of the frequency of
the encoder
Positioning window
Manually operated
axis
Monitoring of the amplitude of
the encoder
Monitoring of the frequency of
the encoder
Positioning window
Following error monitoring
Standstill monitoring
Movement monitoring
Displayed axis Monitoring of the amplitude of
the encoder
Monitoring of the frequency of
the encoder
Positioning window
Following error monitoring
Standstill monitoring
Movement monitoring
Deactivated axis Following error monitoring
Standstill monitoring
Movement monitoring
Monitoring of the amplitude of the
encoder
Monitoring of the frequency of the
encoder
Positioning window
To Next Page
Loading...
