HEIDENHAIN MANUALPLUS 620 - Page 716

716 HEIDENHAIN Technical Manual MANUALplus 620
Entering
compensation
values
The following information must be entered in the <*.COM> tables:
 In the AXISPOS column, enter the compensation points for the
compensation values. The positions are given with respect to the machine
datum (MP_refPosition).
 If required, enter the compensation values measured in the negative
direction of traverse in the BACKLASH column.
 Enter the compensation values to which the compensation points belong in
the column of the axis for which a dependency relationship exists. The
name of the column is the name from CfgAxes/axisList (see Table Format).
Example: The following dependencies apply to the Y axis and Z axis:
 Ball screw pitch error in Z and Y: Z = F(Z) and Y = F(Y)
 Axis sag in Z depending on Y
 Range of traverse: Z axis = 800 mm, Y axis = 500 mm
 Start point for compensation values: Z = –200 mm, Y = –90 mm
 Desired spacing of compensation points: 5 mm
Number of compensation points:
500 mm
5 mm
----------------------
100 compensation points in Y axis
=
800 mm
5 mm
----------------------
160 compensation points in Z axis
=